Led Light Control Box Not Working

Take care not to short the wiring to the pin in the middle in each case.

Led light control box not working.

The led will blink blue three times to indicate that the remote was reset. The factory reset unpairs your remote and tv box so you ll need to re pair them. If you use a remote control to operate the ceiling fan lights the device might need new batteries. Typically if your led lights simply don t work it is not because the products are defective but due to a basic wiring mistake or overlook.

With the connector box open we need to check and make sure that led strip s oval or circular copper pads are properly lined up with the connector s silver pins. If you can see that they aren t aligned right gently move the strip back and forth until the strips light up properly this usually fixes connection issues. Turn the ceiling fan off. Remove the batteries from the remote control and wait for about 10 seconds.

If you are having issues getting anything to work in your led installation or your lighting is inconsistent go over this trouble shooting guide for some pointers on resolving your issue. Press and hold the a triangle and d diamond buttons at the same time for three seconds until the status light changes from red to green. Do not do anything to the right side of the board highlighted red as this is at mains potential and is a shock hazard.